Hernandez Landscaping Co.
} Nov 27, 1. Open face notch, aiming with top cut. Recommended for felling most trees on flat or slightly sloping terrain. Safe and the easiest way to get it right. Recommended method: safe and reliable.
Used for most purposes in flat or slightly sloping terrain. Easier for the bottom cut to meet the angled top cut for directional stumpfelling.clubted Reading Time: 6 mins. Aug 20, The perfect blend of family, community and business!
Northern Woodlands assumes no responsibility or liability arising from forum postings and reserves the right to edit all postings.
City Hall: E Wheatland Rd, Duncanville, TX Hours: a.m. - p.m. M-F Phone:felling cut. The felling cut is in line with or slightly above the level of the directional notch.
+ The hinge remains intact until the tree hits the ground for more control. – Higher stump height. 4. Humboldt cut or inverse notch This is a safe and efficient way to fell a tree that is on a steep slope or prone to splitting.
My concern is that if I cut the leaner
Sep 01, Cut 70% notch into the tree with the length of 80% of the trunk’s diameter. Cut down slide first and then make upward cut to complete the notch.
Make sure that your guy at the truck or atv start pulling little bit more. Then make the back cut toward to the corner of the face notch. The notch is made in the normal manner. Proper way to notch tree for felling bore cut is made in the center of the notch using the lower quadrant of the bar tip.
Cut out as much wood as needed so the bar will reach from both sides. Remove the saw. Start a bore cut at the normal level for a back cut, again using the lower quadrant of the bar.